No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Installation Guide

This is NE40E-M2 V800R010C10SPC500 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Assembling the Straight SMB Female Connector with the Coaxial Cable

Assembling the Straight SMB Female Connector with the Coaxial Cable

This section describes how to assemble the straight BNC female connector with the coaxial cable.

Tools, Equipment and Materials

Wire stripper

Crimper (with a jaw of 2.5 mm (0.1 in.))

Coaxial cable of a 1.6 mm (0.06 in.) core diameter, whose components are shown in Figure 4-32.

Straight SMB female connector, whose components are shown in Figure 4-32.

Figure 4-32 Straight SMB female connector and coaxial cable

Procedure

  1. Strip off the sleeve of the coaxial cable according to the coaxial cable materials and sizes shown in Figure 4-33. The external conductor, insulation and internal conductor should be exposed. See Figure 4-33. Table 4-5 lists the recommended length of the reserved external conductor (L1), reserved insulation (L2) and stripped sleeve (L3). Then, twist the external conductors of the coaxial cable as one.

    Figure 4-33 Stripping off the coaxial cable

    • When stripping off the sleeve of the coaxial cable, do not scratch the external conductor.
    • You can also determine the stripping size according to the size of the connector, as shown in Figure 4-34.
    Figure 4-34 Size of the connector and the stripping size of the coaxial cable

  2. Lead the crimping tube through the coaxial cable, as shown in Figure 4-35.

    Figure 4-35 Leading the crimping sleeve

  3. Unfold the external conductor of the coaxial cable into a trumpet shape, as shown in Figure 4-36.

    Figure 4-36 Unfolding the external conductor of the coaxial cable

  4. Insert the insulation and internal conductor into the connector of the coaxial cable. The external conductor of the coaxial cable partly wraps the external conductor of the connector as shown in Figure 4-37.

    Figure 4-37 Inserting the coaxial connector into the coaxial cable

  5. Use a welding tool to weld the internal conductor of the coaxial cable with the internal conductor of the coaxial connector, as shown in Figure 4-38.

    Figure 4-38 Welding the internal conductor

  6. Push the crimping sleeve toward the connector. Crimp the external conductor of the coaxial cable tight. Use the crimper to tighten the crimping sleeve and the coaxial cable connector, as shown in Figure 4-39. In this way, the straight SMB female connector is assembled with the coaxial cable.

    NOTE:

    Crimp the external conductor of the coaxial cable twice by using the crimper with a jaw of 2.5 mm (0.1 in.). That is, crimp the external connector, rotate it by 90 degree, and then crimp it again.

    Figure 4-39 Crimping the external conductor

Download
Updated: 2019-01-02

Document ID: EDOC1100058424

Views: 10694

Downloads: 60

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next