No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

NE40E-M2 V800R010C10SPC500 Installation Guide

This is NE40E-M2 V800R010C10SPC500 Installation Guide
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing Optical Fibers

Installing Optical Fibers

  • Wear an ESD wrist strap or ESD gloves before installing optical modules.
  • The distance between power cables, ground cables, and signal cables must be greater than 30 mm. The bending radius of an optical fiber must be greater than 40 mm.
  • Cover empty optical interfaces and idle optical modules with dust caps.
  • Do not bundle optical fibers too tightly. You must be able to conveniently remove a single fiber from the bundle.
  • Avoid blocking boards when routing optical fibers.
  1. Attach temporary labels to both ends of each optical fiber.
  2. Arrange optical fibers into a bundle and feed them through the corrugated pipe.
  3. Wrap adhesive tapes on both ends of the corrugated pipe to protect it from cuts, as shown in step 1 in Figure 8-18.
  4. Route the corrugated pipe along the cable ladder.
  5. Insert the corrugated pipe through the dedicated cable hole on the cabinet top to the cabinet about 100 mm and tie the pipe to the cabinet, as shown in step 2 in Figure 8-18.
    Figure 8-18 Inserting the corrugated pipe

  6. Install the optical module, as shown in step 1 in Figure 8-19.
  7. Route optical fibers along the cable tray, remove the dust caps from the optical modules and optical fiber interfaces. Then connect the end of each optical fiber to the corresponding optical interface, as shown in step 2 in Figure 8-19.
  8. Connect the other end of each optical fiber to the ODF.
  9. Bundle optical fibers with binding straps at an interval of 150 mm and fasten the optical fibers to the cable tray.
  10. Attach permanent labels 20 mm from both ends of each optical fiber.
    Figure 8-19 Installing Optical Fibers

Download
Updated: 2019-01-02

Document ID: EDOC1100058424

Views: 9318

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next