No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Routing 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - IP Routing

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining RIPng

Maintaining RIPng

RIPng maintenance is implemented through debugging. Debugging, however, affects the system performance.

Clearing RIPng

To clear RIPng information, run the reset commands in the user view.

Context

RIPng information cannot be restored after you clear it. Therefore, exercise caution when running the reset command.

Procedure

  • Run the reset ripng process-id statistics interface { all | interface-type interface-number [ neighbor neighbor-ipv6-address ] } command to clear the statistics of the counter that is maintained by a particular RIPng process. This command helps to re-collect statistics during debugging.

Debugging RIPng

A device generates debugging information after you enable debugging of modules in the user view. Debugging information shows the contents of the packets sent or received by the debugged modules.

Context

Debugging affects system performance. Therefore, after debugging, run the undo debugging all command to disable it immediately.

When a RIPng fault occurs, run any of the following debugging commands in the user view to debug RIPng and locate the fault.

Procedure

  1. Run the debugging ripng process-id [ error | event | job | backup | interface interface-type interface-number | packet [ interface-type interface-number [neighbor neighbor-address ] ] [ route acl-number ] | route-processing [ acl-number ] ] command to debug the specified RIPng process.
  2. Run the debugging ripng miscellaneous command to debug component-level RIPng information.
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058916

Views: 41853

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next