No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Routing 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - IP Routing
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RIPng Timers

Configuring RIPng Timers

There are four RIPng timers: Update, Age, Suppress, and Garbage-collect timers. You can adjust the RIPng convergence speed by changing the values of the RIPng timers.

Usage Scenario

The value of update is less than that of age, and the value of suppress is less than that of garbage-collect. Setting improper values for the timers affects RIP convergence speed and even causes route flapping on the network. For example, if the value of update is greater than that of age, a device cannot inform its neighbors of the change of RIP routes immediately. Configuring Suppression timers can prevent routing loops. For details, see Configuring Suppression Timers.

Pre-configuration Tasks

Before configuring RIPng timers, complete the following tasks:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ripng [ process-id ]

    A RIPng process is created, and the RIPng view is displayed.

  3. Run timers ripng update age suppress garbage-collect

    RIPng timers are configured.

    By default, the Update timer is 30s; the Age timer is 180s; the Suppress timer is 0s; and the Garbage-collect timer is 120s.

  4. Run commit

    The configuration is submitted.

Checking the Configurations

Run the following commands to check the previous configuration.

  • Run the display ripng command to view the values of RIPng timers.

<HUAWEI> display ripng
  Public vpn-instance name :
    RIPng process : 100
       Preference : 100
       Checkzero : Enabled
       Default Cost : 0
       Maximum number of balanced paths : 6
       Update time   : 30 sec   Age time  : 180 sec
       Suppress time : 0 sec    Garbage-Collect time : 120 sec
       Number of periodic updates sent : 0
       Number of trigger updates sent : 1
       Number of routes in database : 1
       Number of interfaces enabled : 1
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058916

Views: 37543

Downloads: 57

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next