No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Routing 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - IP Routing
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IS-IS IPv6 MT to Isolate Multicast Services from Unicast Services

Configuring IS-IS IPv6 MT to Isolate Multicast Services from Unicast Services

On an IS-IS IPv6 network, IS-IS MT improves usage of network resources by allowing services to run in multiple logical topologies.

Usage Scenario

On a traditional IPv6 network, only one unicast forwarding table is available on the forwarding plane because only one unicast topology exists, which forces services transmitted from one router to the same destination address to share the same next hop, and various end-to-end services such as voice and data services, to share the same physical links. As a result, some links may become heavily congested while others remain relatively idle. In addition, QoS requirements vary based on services. The traditional unicast topology cannot meet various QoS requirements.

IS-IS MT allows multiple separate logical topologies to be deployed in an IS-IS autonomous system (AS). Separate multicast topologies can be set up for multicast services, and this configuration isolates multicast topologies from unicast topologies.

IS-IS MT allows users to configure the network flexibly, reducing network construction cost.

To configure IS-IS MT, perform the following steps. First, associate an IS-IS process with topology instances so that the SPF calculation can be performed for the topology instances in the IS-IS process. Second, associate a specified interface with the topology instances so that every link can participate in the SPF calculation.

Pre-configuration Tasks

Before configuring IS-IS MT to isolate IPv6 multicast services from IPv6 unicast services, complete the following tasks:

Configuration Procedures

Figure 9-8 Configuring IS-IS MT to isolate IPv6 multicast services from IPv6 unicast services

Enabling MT for an IPv6 IS-IS Process

Based on service requirements and the network plan, an IS-IS process can be associated with various topology instances so that multiple logical topologies are deployed in an IS-IS AS.

Context

You can associate an IS-IS process with unicast or multicast topology instances as required so that the SPF calculation can be performed for the topology instances in the IS-IS process. Then, you can configure parameters, such as the interface cost and protocol priority for the topology instances.

The configuration in an IS-IS topology instance view takes effect only on the topology instance. Therefore, you can configure different features and parameters for different topology instances as required.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ipv6 topology topology-name

    An IPv6 topology instance is configured.

  3. Run isis [ process-id ]

    The IS-IS view is displayed.

  4. Run cost-style { wide | wide-compatible }

    The cost style of packets sent and received by the NE is set to wide or wide-compatible.
    NOTE:
    Go to Step 5 or Step 6 as required.
    • If the NE supports only unicast services, go to Step 5.
    • If the NE supports only multicast services, go to Step 6.
    • If the NE supports both unicast and multicast services, perform the following steps.

  5. Run ipv6 topology topology-name topology-id topology-id

    The IS-IS process is associated with a specified unicast topology instance, and the IS-IS unicast topology instance view is displayed.

  6. Run ipv6 topology multicast topology-id multicast

    The IS-IS process is associated with a specified multicast topology instance, and the IS-IS multicast topology instance view is displayed.

  7. (Optional) Configure IS-IS features for IPv6 topology instances using the following commands:

    • To set the priority of IS-IS, run the ipv6 preference command.

    • To enable an IS-IS device to generate a default route, run the ipv6 default-route-advertise command.

    • To enable an IS-IS device to import routes from other routing protocols in the IS-IS view, run the ipv6 import-route command.

    • To control IS-IS route leaking from a Level-1 area to a Level-2 area, run the ipv6 import-route isis level-1 into level-2 command.

    • To control IS-IS route leaking from a Level-2 area to a Level-1 area, run the ipv6 import-route isis level-2 into level-1 command.

    • To enable IS-IS summarization, run the summary command.

  8. Run commit

    The configuration is committed.

Enabling MT for an IPv6 IS-IS Interface

After IS-IS MT is enabled, associate a specified interface with MT instances.

Context

Various topology instances can be associated with one interface so that specified links of the interface can participate in the SPF calculation for the topology instances.

The following parameters can be configured for an interface in different topology instances:
  • Cost of the interface in each topology instance

  • Administrative tag of the interface in each topology instance

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ipv6 topology topology-name enable

    An IS-IS IPv6 topology instance is enabled for the interface.

  4. Run isis ipv6 topology topology-name

    The interface is associated with the IS-IS IPv6 topology instance.

    NOTE:

    If you want to associate an interface with multiple IPv6 topology instances, repeat this step and specify different topology names.

  5. (Optional) Run isis ipv6 topology topology-name cost cost [ level-1 | level-2 ]

    A cost is configured for the interface in the IS-IS topology instance.

    A cost change on an interface will trigger route reselection. Therefore, change the cost during network planning. By default, the cost of an IS-IS interface in a topology instance is 10.

  6. (Optional) Run isis ipv6 topology topology-name tag-value tag [ level-1 | level-2 ]

    An administrative tag is configured for the interface in the IS-IS topology instance.

    An administrative tag is carried in routes and used by route-policies to filter routes. By default, no administrative tag is configured for an IS-IS interface.

  7. Run commit

    The configuration is committed.

Verifying the Configuration of IS-IS IPv6 Multi-Topologies Used to Isolate Multicast Services from Unicast Services

After configuring IPv6 IS-IS MT to isolate multicast services from unicast services, check the IS-IS MT configurations.

Prerequisites

IPv6 IS-IS MT has been configured to isolate multicast services from unicast services.

Procedure

  • Run the display isis peer [ verbose ] [ process-id | vpn-instance vpn-instance-name ] command to check information about IS-IS neighbors.
  • Run the display isis route [ process-id | vpn-instance vpn-instance-name ] ipv6 [ topology topology-name ] [ verbose | [ level-1 | level-2 ] | ip-address [ mask | mask-length ] ] * command to check IS-IS routing information.
  • Run the display isis spf-tree [ systemid systemid ] [ [ level-1 | level-2 ] | ipv6 | topology topology-name ] * verbose [ process-id | vpn-instance vpn-instance-name ] command to check IS-IS SPT information.

Example

Run the display isis peer verbose command to view IS-IS neighbor information. The command output shows that the neighbor status is Up and that the topology instance ID is 10.

<HUAWEI> display isis peer verbose

Run the display isis route ipv6 topology blue command to view routing information about IS-IS topology instance blue.

<HUAWEI> display isis route ipv6 topology blue
                         Route information for ISIS(1)
                         -----------------------------

                               ipv6 topology blue
                               -----------------
                          ISIS(1) level-1 Forwarding Table
                          --------------------------------

 IPV4 Destination  IntCost  ExtCost  ExitInterface  NextHop                   Flags
-----------------------------------------------------------------------------------
30:1::/64          10       NULL    GE0/1/2         FE80::2E0:6CFF:FE57:8300  D/-/L/- 

       Flags: D-Direct, A-Added to URT, L-Advertised in LSPs, S-IGP Shortcut,
                                 U-Up/Down Bit Set 

Run the display isis spf-tree ipv6 topology blue command to view SPT information about IS-IS IPv6 topology instance blue.

<HUAWEI> display isis spf-tree ipv6 topology blue
                          Shortest Path Tree for ISIS(1)
                          ---------------------------------
                                ipv6 topology blue
                                ------------------
            Flags: I-Node is invalid       R-Node is directly reachable
                   O-Node is overload      A-Node is affected
                   U-Link is upward        D-Link is downward
                   F-Link is not on tree   N-Neighbor is attached to link
                   S-Link is IGP Shortcut

                          ISIS(1) Level-1 Shortest Path Tree

 Node              NodeFlag  Distance  Link                 LinkFlag   LinkCost
 ------------------------------------------------------------------------------
0000.0000.0001.00  -/-/-/-   0                                                  
                                        ->0000.0000.0001.01      D     10       
0000.0000.0001.01  -/R/-/-   10                                                 
                                        ->0000.0000.0001.00      U     0        
                                        ->0000.0000.0002.00      D     0        
0000.0000.0002.00  -/-/-/-   10                                                 
                                        ->0000.0000.0001.01      U     10       

                          ISIS(1) Level-2 Shortest Path Tree

 Node              NodeFlag  Distance  Link                 LinkFlag   LinkCost
 ------------------------------------------------------------------------------
0000.0000.0001.00  -/-/-/-   0                                                  
                                        ->0000.0000.0001.01      D     10       
0000.0000.0001.01  -/R/-/-   10                                                 
                                        ->0000.0000.0001.00      U     0        
                                        ->0000.0000.0002.00      D     0        
0000.0000.0002.00  -/-/-/-   10                                                 
                                        ->0000.0000.0001.01      U     10       

Run the display isis spf-tree ipv6 topology multicast command, and you can view SPT information about the IS-IS IPv6 multicast topology instance.

<HUAWEI> display isis spf-tree ipv6 topology multicast
                          Shortest Path Tree for ISIS(1)
                          ---------------------------------
                                ipv6 topology multicast
                                ------------------
            Flags: I-Node is invalid       R-Node is directly reachable
                   O-Node is overload      A-Node is affected
                   U-Link is upward        D-Link is downward
                   F-Link is not on tree   N-Neighbor is attached to link
                   S-Link is IGP Shortcut

                          ISIS(1) Level-1 Shortest Path Tree

 Node              NodeFlag  Distance  Link                 LinkFlag   LinkCost
 ------------------------------------------------------------------------------
0000.0000.0001.00  -/-/-/-   0                                                  
                                        ->0000.0000.0001.01      D     10       
0000.0000.0001.01  -/R/-/-   10                                                 
                                        ->0000.0000.0001.00      U     0        
                                        ->0000.0000.0002.00      D     0        
0000.0000.0002.00  -/-/-/-   10                                                 
                                        ->0000.0000.0001.01      U     10       

                          ISIS(1) Level-2 Shortest Path Tree

 Node              NodeFlag  Distance  Link                 LinkFlag   LinkCost
 ------------------------------------------------------------------------------
0000.0000.0001.00  -/-/-/-   0                                                  
                                        ->0000.0000.0001.01      D     10       
0000.0000.0001.01  -/R/-/-   10                                                 
                                        ->0000.0000.0001.00      U     0        
                                        ->0000.0000.0002.00      D     0        
0000.0000.0002.00  -/-/-/-   10                                                 
                                        ->0000.0000.0001.01      U     10       
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058916

Views: 38049

Downloads: 57

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next