No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - System Monitor 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - System Monitor
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining IP FPM

Maintaining IP FPM

This section describes how to maintain IP Flow Performance Monitor (FPM) by configuring the alarm thresholds for IP FPM performance and monitoring IP FPM performance statistics.

Configuring Alarm and Clear Alarm Thresholds for IP FPM Performance Counters

After you configure the alarm threshold and its clear alarm threshold for packet loss or delay, the device generates an alarm when the packet loss rate or delay reaches the alarm threshold and clears the alarm when the packet loss rate or delay falls below the clear alarm threshold. The alarm functions help network operation and maintenance.

Context

If the packet loss rate or delay on a network is detected high but left unattended, the packet loss rate or delay may increase and potentially affect user experience. To help network operation and maintenance, configure the alarm threshold and its clear alarm threshold for packet loss or delay.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run nqa ipfpm mcp

    The IPFPM-MCP view is displayed.

  3. Run instance instance-id

    The IP FPM instance view is displayed.

  4. Run loss-measure ratio-threshold upper-limit upper-limit lower-limit lower-limit

    The packet loss alarm threshold and its clear alarm threshold are configured.

  5. Run either of the following commands to configure the delay alarm threshold and its clear alarm threshold.

    • When the target flow is unidirectional, run the delay-measure one-way delay-threshold upper-limit upper-limit lower-limit lower-limit command to configure the one-way delay alarm threshold and its clear alarm threshold.

    • When the target flow is bidirectional, run the delay-measure two-way delay-threshold upper-limit upper-limit lower-limit lower-limit command to configure the two-way delay alarm threshold and its clear alarm threshold.

Monitoring the IP FPM Running Status

This section describes how to monitor the IP FPM running status.

Context

Run the display commands in any view to check the IP FPM performance statistics and monitor the IP FPM running status in routine maintenance.

Procedure

  • Run the display ipfpm statistic-type { loss | oneway-delay | twoway-delay } instance instance-id command to check the performance statistics for a specified IP FPM instance.
  • Run the display ipfpm statistic-type { loss | oneway-delay | twoway-delay } instance instance-id ach ach-id [ verbose ] command to check the hop-by-hop performance statistics for a specified ACH.
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058924

Views: 7020

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next