No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - System Monitor 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - System Monitor
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Session-Reflector

Configuring the Session-Reflector

This section describes how to configure the session-reflector. The session-reflector replies to the probes sent by the session-sender after being notified by the server.

Context

After the session-reflector is configured, the session-reflector can reply to the session-sender with timestamps and serial numbers to help collect statistics about the delay, jitter, and packet loss rate.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run nqa twamp

    The TWAMP view is displayed.

  3. Run reflector

    The session-reflector function is enabled, and the session-reflector view is displayed.

  4. (Optional) Run test-session inactive inactive-interval

    An inactive interval is configured for a test session.

    By default, the inactive interval of a test session is 900s.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058924

Views: 7072

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next