No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring SVC VPWS

Configuring SVC VPWS

Usage Scenario

A static PW does not use signaling protocols to send L2VPN packets. Packets are transmitted between PEs over a tunnel.

The tunnel carrying a static PW can be an LDP LSP, an MPLS TE tunnel, or a GRE tunnel. By default, an LDP LSP is used.

Pre-configuration Tasks

Before configuring SVC VPWS, complete the following tasks:

  • Configure static routes or an IGP protocol on PEs and Ps on the MPLS backbone network to ensure IP connectivity.

  • Configure basic MPLS functions on PEs and Ps of the MPLS backbone network.

  • Establish tunnels between PEs based on the tunnel policy (if no tunnel policy is configured, the default tunnel policy LDP is used).

Configuration Procedures

Figure 7-8 Configuring SVC VPWS

Figure 7-9 Configuring SVC VPWS

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 32919

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next