No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Capability of Exchanging External Routes Between the Level 2 Carrier PEs

Configuring the Capability of Exchanging External Routes Between the Level 2 Carrier PEs

The MP-BGP peer relationship is established between PEs of the second carrier to exchange IPv4 VPN routes.


  • Perform the following steps on the Level 2 carrier's PE that accesses the clients:
    1. Run system-view

      The system view is displayed.

    2. Run bgp { as-number-plain | as-number-dot }

      The BGP view is displayed.

    3. Run peer ipv4-address as-number { as-number-plain | as-number-dot }

      The remote PE is configured as the BGP peer.

    4. Run peer ipv4-address connect-interface loopback interface-number

      The interface used to establish the TCP connection is specified.

    5. (Optional) Run peer ipv4-address ebgp-max-hop [ hop-count ]

      The maximum number of hops in the EBGP connection is specified.

      If the PEs of the Level 2 carrier establish the EBGP peer relationship, the Step 5 must be followed.

    6. Run ipv4-family vpnv4

      The BGP-VPNv4 sub-address family view is displayed.

    7. Run peer ipv4-address enable

      The capacity of VPNv4 route exchange with the peer is enabled.

    8. Run commit

      The configuration is committed.

Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 36077

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next