No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Tunnel Policy Configuration

Verifying the Tunnel Policy Configuration

After configuring a tunnel policy for the backbone network of a BGP/MPLS IP VPN, check the name of and configurations of the tunnel policy.

Prerequisites

A tunnel policy has been configured for the backbone network of the BGP/MPLS IP VPN.

Procedure

  • Run the display tunnel-policy policy-name command to check the configurations of a specified tunnel policy.
  • Run the display ip vpn-instance verbose [ vpn-instance-name ] command to check the tunnel policy used by a VPN instance.

Example

Run the display tunnel-policy command. If the configuration of a tunnel policy is displayed, the configuration succeeds.

<HUAWEI> display tunnel-policy policy1
Tunnel Policy Name                      Select-Seq                   Load balance No  Unmix
--------------------------------------------------------------------------------------------
policy1                                 LSP CR-LSP                                 3 Disable

Run the display ip vpn-instance verbose command. The command output shows the tunnel policy used by a VPN instance. In the following command output, the tunnel policy used by the IPv4 address family of a VPN instance named vpn1 is policy1.

<HUAWEI> display ip vpn-instance verbose
 Total VPN-Instances configured : 1
 Total IPv4 VPN-Instances configured : 1
 Total IPv6 VPN-Instances configured : 0
 
 VPN-Instance Name and ID : vpn1, 1
  Interfaces : GigabitEthernet0/1/0
 Address family ipv4
  Create date : 2006/09/27 15:25:29
  Up time : 0 days, 00 hours, 02 minutes and 11 seconds
  Vrf Status : UP
  Route Distinguisher : 100:1
  Export VPN Targets :  2:2
  Import VPN Targets :  1:1
  Label policy : label per route
Tunnel Policy : policy1
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27746

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next