No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PW APS

Configuring PW APS

Pseudo wire (PW) automatic protection switching (APS) applies to scenarios in which the primary and secondary PWs share the same source and destination. The PWs can be single-segment PWs, multi-segment PWs, dynamic PWs, or static PWs.

Usage Scenario

In a PW APS scenario, PW OAM detects the status of the primary and secondary PWs. When PW OAM detects a fault on the active PW, PW OAM immediately notifies PW APS of the fault and triggers PW APS to perform an active/standby PW switchover. Figure 7-16 and Figure 7-17 show PW APS networking for multi-segment and single-segment PWs respectively.

Figure 7-16 PW APS networking for multi-segment PWs

Figure 7-17 PW APS networking for single-segment PWs

Pre-configuration Tasks

Before configuring PW APS, complete the following tasks:

  • Configure IP addresses and an IGP on PEs.

  • Establish public network tunnelsor BGP LSPs between PEs. The public network tunnels can be:

    • LDP LSPs: To establish an LDP LSP, you must enable MPLS and MPLS LDP both globally and on specific interfaces for each node along the tunnel. If two PEs are indirectly connected, establish a remote LDP session between them.

    • TE tunnels: To establish a TE tunnel, you must enable MPLS, MPLS TE, and RSVP-TE both globally and on specific interfaces for each node along the tunnel, and enable CSPF in the MPLS view of the tunnel ingress. Of course you can also configure CR-LSP.

      NOTE:

      Because pseudo wire emulation edge-to-edge (PWE3) uses the Label Distribution Protocol (LDP) to distribute VPN labels, you must globally enable MPLS LDP on PEs and establish remote MPLS LDP sessions if TE tunnels are used as public network tunnels.

      If the public network tunnels are not LDP tunnels, you must configure tunnel policies and apply them to these public network tunnels.

  • Enable MPLS L2VPN on PEs.

Configuration Procedures

Figure 7-18 Flowchart for configuring PW APS

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27695

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next