No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Auto Loop Detection

Enabling Auto Loop Detection

Context

Perform the following steps on each PE.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run loop-detect trigger enable

    Auto loop detection is enabled.

  3. (Optional) Run loop-detect trigger min-port-uptime

    The period after which the system starts Auto loop detection on an interface is specified. The period is counted after the interface status changes from Down to Up.

  4. (Optional) Run loop-detect trigger min-slot-uptime

    The period after which the system starts Auto loop detection is specified. The period is counted after the control board starts.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27524

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next