No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of VPLS

Monitoring the Running Status of VPLS

You can view VPLS information by monitoring the running status of VPLS.

Context

In routine maintenance, you can run the following commands in any view to check the running of VPLS.

Procedure

  1. Run the display vsi [ name vsi-name ] [ verbose ] command to check information about VPLS VSIs.
  2. Run the display vsi remote ldp [ [ router-id ip-address ] [ pw-id pw-id ] | unmatch | verbose ] command to check information about the remote VSI.
  3. Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command to check information about the VPLS connection.
  4. Run the display vsi pw out-interface [ vsi vsi-name ] command to check information about the outbound interface of the VSI PW.
  5. Run the display l2vpn vsi-list tunnel-policy policy-name command to check information about the tunnel policy used by the VSI.
  6. Run the display vpls forwarding-info [ state { up | down } | vsi vsi-name [ peer peer-address [ negotiation-vc-id vc-id ] ] ] [ verbose ] command to check the forwarding information of all VSIs.
  7. Run the display vsi services { vsi-name | all | interface interface-type interface-number | vlan vlan-id } command to check information about the AC interface associated with the VSI.
  8. Run the display admin-vsi binding [ admin-vsi vsi-name ] command to check information about the binding of the mVSI and the service VSI.
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27277

Downloads: 51

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next