No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding Interfaces to a VPN Instance

Binding Interfaces to a VPN Instance

After an interface is bound to a VPN instance, the interface becomes a part of the VPN. Packets entering the interface will be forwarded based on the VRF table of the VPN.

Context

After a VPN instance is configured on a PE, an interface that belongs to the VPN must be bound to the VPN instance. Otherwise, the interface functions as a public network interface and cannot forward VPN data.

Perform the following steps on each PE that connects to CEs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ip binding vpn-instance vpn-instance-name

    The interface is bound to the VPN instance.

    NOTE:

    Using the ip binding vpn-instance command will delete Layer 3 (including IPv4 and IPv6) configurations, such as the IP address and routing protocol, on the interface. Reconfigure them after using the ip binding vpn-instance command if needed.

  4. Run ip address ip-address { mask | mask-length }

    An IP address is configured for the interface.

    Some Layer 3 features, such as route exchange between the PE and CE, can be configured only after an IP address is configured for the VPN interface on the PE.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 28095

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next