No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Limitations for BGP/MPLS IP VPN-NE08E

Limitations for BGP/MPLS IP VPN-NE08E




When tier-1 and tier-2 carriers access each other through multiple EBGP links, traffic is forwarded only through a single interface.

Use a trunk interface to implement link aggregation.

If an outbound interface fails, traffic is switched to the other path after convergence is complete.

In the unicast address family view, configuration of the peer label capability and configuration of the labeled address family are mutually exclusive. The ipv4-family labeled-unicast command and the peer label-route-capability (BGP) command are mutually exclusive.

The neighbor label capability and labeled address family capability cannot be both enabled in the unicast address family view.


The per-next-hop-per-label POPGO mode does not support load balancing.

The per-next-hop-per-label POPGO mode and VPN route load balancing are mutually exclusive.

One channel is selected based only on the incoming label for forwarding.

Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 36303

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next