No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Maintaining GRE

Maintaining GRE

This section describes how to reset the statistics of a tunnel interface and monitor the GRE running status.

Resetting the Statistics of a Tunnel Interface

When you need to reset the statistics of a tunnel interface, you can run the reset commands to clear the Keepalive packets and Keepalive Response packets sent and received by a GRE tunnel interface.

Procedure

  • Reset statistics about Keepalive packets on the tunnel interface.
    1. Run system-view

      The system view is displayed.

    2. Run interface tunnel interface-number

      The tunnel interface view is displayed.

    3. Run reset keepalive packets count

      Reset the statistics on Keepalive packets on the tunnel interface.

      NOTE:

      You can run the reset keepalive packets count command only in the tunnel interface view, and the interface tunnel protocol must be GRE.

Monitoring the Running Status of GRE

In routine maintenance, you can run the GRE related display commands to view the GRE running status.

Procedure

  • Run the display interface tunnel [ interface-number ] command to check the tunnel interface running status.
  • Run the display ip routing-table vpn-instance vpn-instance-name command to check the VPN routing table on the PE.
  • Run the display ip routing-table command to check the routing table on the CE.
  • Run the ping [ -a source-ip-address | -vpn-instance vpn-instance-name ] * host command to check whether two ends of the tunnel can communicate with each other.
  • Run the display keepalive packets count command to check the numbers of Keepalive messages and Keepalive response messages sent and received by a GRE tunnel interface.
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 37095

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next