No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating the L3VE Sub-interface Terminated by Dot1q

Creating the L3VE Sub-interface Terminated by Dot1q

If one tag is carried by a user packet, the sub-interface for Dot1q VLAN tag termination accesses the L3VPN.

Context

Do as follows on NPEs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface virtual-ethernet interface-number.subinterface-number

    A L3VE sub-interface is created the sub-interface view is displayed.

  3. Run control-vid vid dot1q-termination

    The sub-interface is encapsulated into the Dot1q termination mode.

  4. Run dot1q termination vid low-pe-vid [ to high-pe-vid ]

    The Dot1q termination is configured for the L3VE sub-interface.

  5. Run arp broadcast enable

    The ARP broadcast function is enabled for the sub-interface for Dot1q VLAN tag termination.

    When you enable or disable the ARP broadcast function on a termination sub-interface, the routing status of the sub-interface becomes Down and then Up. This may result in a flapping of routes on the entire network, affecting the normal operation of services.

  6. Run ip binding vpn-instance vpn-instance-name

    The L3VE sub-interface is associated with a VPN instance.

  7. Run ip address ip-address { mask | mask-length } [ sub ]

    The IP address is configured.

    NOTE:

    The IP address is a private network address of MPLS L3VPN.

  8. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 28093

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next