No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring BFD for PW

(Optional) Configuring BFD for PW

After configuring PWs, configure BFD for PW to detect the faults of the primary PW to speed up fault detection and improve PW switching performance.

Context

If only signaling is used to detect PW faults, PWs are slow to become aware of faults. BFD for PW is often used to quickly detect PW faults.

Generally, BFD for PW only needs to be configured for the primary PW. When BFD for PW detects a fault on the primary PW, BFD for PW immediately triggers an active/standby PW switching.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bfd

    BFD is enabled globally, and the BFD view is displayed.

  3. Run quit

    Return to the system view.

  4. On the UPE or NPE configured with a VSI, run bfd cfg-name bind pw vsi vsi-name peer peer-address [ vc-id vc-id ] [ remote-peer remote-peer-address pw-ttl { auto-calculate | ttl-number } ]

    BFD for PW is configured to detect VSI PW faults.

    NOTE:
    When configuring BFD for PW, be sure to configure the ignore-standby-state command on the SPE. If you do not configure the ignore-standby-state command, the secondary PW remains blocked and the BFD session cannot go Up. Similarly, if you do not configure the ignore-standby-state command, the primary PW stays in the backup state during a delayed traffic switchback and the BFD session cannot go Up.

  5. Run the following commands to configure BFD session discriminators:

    • Run discriminator local discr-value

      A local discriminator is configured.

    • Run discriminator remote discr-value

      A remote discriminator is configured.

    The local discriminator on one end of the BFD session must be the same as the remote discriminator on the other end of the BFD session.

  6. Run commit

    The configuration is committed.

    If the status of a PW is Down, the BFD session can be established but cannot go Up.

    NOTE:
    You must configure or cancel BFD for PW on both ends of a PW. Otherwise, the PW status on both ends may be inconsistent.

  7. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 33408

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next