No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the LDP HVPLS Configuration

Verifying the LDP HVPLS Configuration

After configuring LDP HVPLS, check information about VSIs, remote VSIs, VPLS connections, outbound interfaces of VSI PWs, and tunnel policies applied to VSIs.

Prerequisites

LDP HVPLS has been configured.

Procedure

  • Run the display vsi [ name vsi-name ] [ verbose ] command to check information about VPLS VSIs.
  • Run the display vsi mac-withdraw loop-detect command to check information about MAC Withdraw message loops.

Example

Run the display vsi [ name vsi-name ] [ verbose ] command. The command output shows that VSI State is up. If verbose is configured, you can also find that PW Signaling is ldp.

<HUAWEI> display vsi name vsi123 verbose
 ***VSI Name               : v123
    Administrator VSI      : no
    Isolate Spoken         : disable
    VSI Index              : 1
    PW Signaling           : ldp
    Member Discovery Style : --
    Bridge-domain Mode     : disable
    PW MAC Learning Style  : unqualify
    Encapsulation Type     : vlan
    MTU                    : 1500
    Diffserv Mode          : uniform
    Service Class          : --
    Color                  : --
    DomainId               : 255
    Domain Name            :
    Ignore AcState         : disable
    P2P VSI                : disable
    Create Time            : 0 days, 0 hours, 20 minutes, 49 seconds
    VSI State              : up
    Resource Status        : --

    VSI ID                 : 123
   *Peer Router ID         : 2.2.2.2
    primary or secondary   : primary
    ignore-standby-state   : no
    VC Label               : 19
    Peer Type              : dynamic
    Session                : up
    Tunnel ID              : 0x0000000001004c4b41
    Broadcast Tunnel ID    : --
    Broad BackupTunnel ID  : --
    CKey                   : 2
    NKey                   : 788529260
    Stp Enable             : 0
    PwIndex                : 2
    Control Word           : disable
   *Peer Router ID         : 3.3.3.3
    primary or secondary   : primary
    ignore-standby-state   : no
    VC Label               : 18
    Peer Type              : dynamic
    Session                : up
    Tunnel ID              : 0x0000000001004c4b42
    Broadcast Tunnel ID    : --
    Broad BackupTunnel ID  : --
    CKey                   : 1
    NKey                   : 788529259
    Stp Enable             : 0
    PwIndex                : 1
    Control Word           : disable

  **PW Information:

   *Peer Ip Address        : 2.2.2.2
    PW State               : up
    Local VC Label         : 19
    Remote VC Label        : 19
    Remote Control Word    : disable
    PW Type                : MEHVPLS
    Tunnel ID              : 0x0000000001004c4b41
    Broadcast Tunnel ID    : --
    Broad BackupTunnel ID  : --
    Ckey                   : 2
    Nkey                   : 788529260
    Main PW Token          : 0x0
    Slave PW Token         : 0x0
    Tnl Type               : ldp
    OutInterface           : LDP LSP
    Backup OutInterface    : --
    Stp Enable             : 0
    PW Last Up Time        : 2012/12/05 07:05:36
    PW Total Up Time       : 0 days, 0 hours, 18 minutes, 34 seconds
   *Peer Ip Address        : 3.3.3.3
    PW State               : up
    Local VC Label         : 18
    Remote VC Label        : 19
    Remote Control Word    : disable
    PW Type                : label
    Tunnel ID              : 0x0000000001004c4b42
    Broadcast Tunnel ID    : --
    Broad BackupTunnel ID  : --
    Ckey                   : 1
    Nkey                   : 788529259
    Main PW Token          : 0x0
    Slave PW Token         : 0x0
    Tnl Type               : ldp
    OutInterface           : LDP LSP
    Backup OutInterface    : --
    Stp Enable             : 0
    PW Last Up Time        : 2012/12/05 07:05:59
    PW Total Up Time       : 0 days, 0 hours, 18 minutes, 2 seconds

After you configure MAC Withdraw loop detection on a PE, run the display vsi [ name vsi-name ] mac-withdraw loop-detect command. The command output shows information about MAC Withdraw message loops.

<HUAWEI> display vsi mac-withdraw loop-detect
Total number of vsi detect loop is 2.
Support max hop 255.

Vsi name        : VSI1
Last loop type  : detect loop
Send peer       : 5.5.5.5
Receive peer    : 2.2.2.2
Last loop time  : 2012/10/26 11:35:59

Vsi name        : VSI2
Last loop type  : exceed max hop
Send peer       : 5.5.5.5
Receive peer    : 3.3.3.3
Last loop time  : 2012/10/26 11:35:59
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 33291

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next