No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Reflection to Optimize the VPN Backbone Layer

Configuring Route Reflection to Optimize the VPN Backbone Layer

Using an RR helps reduce the number of MP-IBGP connections between PEs. The RR not only reduces the burden on PEs, but also facilitates network maintenance and management.

Usage Scenario

If too many PEs reside on the VPN backbone layer and these PEs need to establish MP-IBGP peer relationships to exchange VPN routes, you can configure route reflection to optimize the VPN backbone layer.

A BGP speaker does not advertise the routes learned from an IBGP peer to other IBGP peers. To enable a PE to advertise the routes of the VPN that the PE accesses to the BGP VPNv4 peers in the same AS, the PE must establish IBGP peer relationships with all peers to directly exchange VPN routing information. In other words, MP-IBGP peers must be fully meshed. If there are n PEs (including ASBRs) in an AS, n (n-1)/2 MP-IBGP peer relationships need to be established. A large number of IBGP peers consume a great number of network resources. After an RR is configured, each PE needs to set up an MP-IBGP peer relationship with only the RR, that is, only n pairs of MP-IBGP peers are required.

Pre-configuration Tasks

Before configuring route reflection to optimize the VPN backbone layer, complete the following tasks:

  • Configure a routing protocol on the MPLS backbone network to ensure IP connectivity on the backbone network.

  • Establish tunnels (LSPs or MPLS TE tunnels) between all the PEs.

Configuration Procedures

Figure 5-4 Flowchart for configuring route reflection to optimize the VPN backbone layer
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 30209

Downloads: 55

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next