No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Access to the Public Network or an L3VPN

Configuring the Access to the Public Network or an L3VPN

The configuration of an L3VE interface that accesses the public network or MPLS L3VPN varies with the networking environments.

Context

Do as follows on NPEs.

Procedure

  • Configuring a user to access the public network
    1. Run system-view

      The system view is displayed.

    2. Run interface virtual-ethernet interface-number.subinterface-number

      The L3VE sub-interface view is displayed.

    3. Run vlan-type dot1q vlan-id

      The VLAN ID of the L3VE sub-interface is configured.

    4. Run ip address ip-address { mask | mask-length }

      An IP address is configured for the L3VE interface.

      NOTE:
      The IP address is a public network IP address.

    5. Configure a routing protocol on the NPEs to exchange routes with the CE device on the MPLS L2VPN network.

      For more information, refer to the NE Configuration Guide - IP Routing.

    6. (Optional) Run mpls l2vpn l3ve delay-up

      A delay is configured for the L3VE interface to go Up after a faulty L2VPN service recovers.

    7. Run commit

      The configuration is committed.

  • Configuring a user to access the MPLS L3VPN network
    1. Run system-view

      The system view is displayed.

    2. Run interface virtual-ethernet interface-number.subinterface-number

      The L3VE interface view is displayed.

    3. Run vlan-type dot1q vlan-id

      The VLAN ID of the L3VE sub-interface is configured.

    4. Run ip binding vpn-instance vpn-instance-name

      The L3VE interface is associated with a VPN instance.

    5. Run ip address ip-address { mask | mask-length }

      An IP address is configured for the L3VE interface.

      NOTE:

      The IP address is a private network address of MPLS L3VPN.

    6. (Optional) Run mpls l2vpn l3ve delay-up

      A delay is configured for the L3VE interface to go Up after a faulty L2VPN service recovers.

    7. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27502

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next