No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of L2VPN Accessing L3VPN

Overview of L2VPN Accessing L3VPN

Multiprotocol Label Switching (MPLS) is widely applied in Metropolitan Area Networks (MANs) because it features high reliability, high security, and sound IP-based operation and maintenance capabilities, and supports quality of service (QoS). A Layer 2 virtual private network (L2VPN) provides MPLS-based L2VPN services to transparently transmits Layer 2 user data over tunnels on an MPLS network. This reduces the number of label switched paths (LSPs) maintained by transit nodes.

Figure 10-1 Traditional L2VPN accessing L3VPN

On a traditional network, a provider edge aggregation (PE-AGG) and a network provider edge (NPE) are required to connect the access network to the bearer network. Then, the L2VPN can access the public network or Layer 3 virtual private network (L3VPN).

On the network shown in Figure 10-1, the user provider edges (UPEs) are responsible for providing access services for user sites by creating an L2VPN tunnel between the access network and PE-AGG. The PE-AGG terminates the L2VPN and connects to the NPE. An L3VPN is set up between the NPE and other common PEs on the bearer network of the carrier. As a CE of the L2VPN, the NPE connects to the PE-AGG. For the L3VPN on the bearer network, CE1 accesses the L3VPN over the leased line emulated by the L2VPN.

Figure 10-2 L2VPN accessing L3VPN supported by the NE

If an NPE can provide the functions of a PE-AGG and an NPE, it helps lower the networking costs and simplify the networking. As shown in Figure 10-2, the NPE terminates an L2VPN and accesses an L3VPN over a virtual Ethernet (VE) group. The NPE provides the functions of the PE-AGG and NPE in the traditional networking.

In a VE group, the VE interface used to terminate an L2VPN is called a Layer 2 Virtual Ethernet (L2VE) interface, and the VE interface used to access an L3VPN is called a Layer 3 Virtual Ethernet (L3VE) interface.

An NPE supports the division of multiple VSs. To implement L2VPN and L3VPN service interworking between different VSs, you can allocate the L2VE and L3VE interfaces in the same VE group to different VSs.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27631

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next