No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an RR to Establish MP-IBGP Peer Relationships with All Client PEs

Configuring an RR to Establish MP-IBGP Peer Relationships with All Client PEs

You can configure an RR to establish MP-IBGP peer relationships with all its client PEs to reflect VPNv4 routes.


  • Configure the RR to establish an MP-IBGP peer relationship with each client PE.

    Perform Steps 3 to 6 repeatedly on the RR to establish MP-IBGP peer relationships with all client PEs.

    1. Run system-view

      The system view is displayed.

    2. Run bgp as-number

      The BGP view is displayed.

    3. Run peer peer-ipv4-address as-number as-number

      The client PE is specified as a BGP peer.

    4. Run peer peer-ipv4-address connect-interface interface-type interface-number

      The interface used to establish a TCP connection is specified.

      The IP address of the interface must be the same as the MPLS LSR ID. It is recommended that you specify a loopback interface to establish the TCP connection.

    5. Run ipv4-family vpnv4

      The BGP-VPNv4 address family view is displayed.

    6. Run peer peer-ipv4-address enable

      The function to exchange VPNv4 routes with client PEs is enabled.

    7. Run commit

      The configuration is committed.

Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 31912

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next