No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Advertising the Routes of a PE in the Local AS to the Remote PE

Advertising the Routes of a PE in the Local AS to the Remote PE

After the routes of the loopback interface on a PE in an AS are advertised to the remote PE in another AS, the MP-EBGP peer relationship is established between PEs.

Procedure

  • Configure an ASBR to advertise the loopback address of a PE in the local AS to the remote ASBR.

    Perform the following steps on each ASBR:

    1. Run system-view

      The system view is displayed.

    2. Run bgp as-number

      The BGP view is displayed.

    3. Run network ip-address [ mask | mask-length ]

      The function to advertise the loopback address of a PE in the local AS to the remote ASBR is enabled.

    4. Run quit

      Return to the system view.

    5. Run commit

      The configuration is committed.

  • Configure the peer ASBR to import BGP routes to an IGP.

    Perform the following steps on the peer ASBR:

    1. Run system-view

      The system view is displayed.

    2. Run ospf process-id

      The OSPF view is displayed.

    3. Run import-route bgp [ cost cost ] [ route-policy route-policy-name ]

      The BGP routes are imported to the IGP.

    4. Run quit

      Return to the system view.

    5. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27510

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next