No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Static PW FRR Configuration

Verifying the Static PW FRR Configuration

After configuring static PW FRR, check static PW information.

Prerequisites

Static PW FRR has been configured.

Procedure

  • Run the display mpls static-l2vc [ vc-id | interface interface-type interface-number | state { down | up } | brief ] command on a PE to check static PW information.
  • Run the display mpls switch-l2vc [ brief | state { up | down } | ip-address vc-id encapsulation encapsulation-type ] command on an SPE to check switched PW information.

Example

Run the display mpls static-l2vc [ vc-id | interface interface-type interface-number | state { down | up } | brief ] command. The command output shows that VC State is up.

Run the display mpls switch-l2vc [ brief | state { up | down } | ip-address vc-id encapsulation encapsulation-type ] command. The command output shows that VC State is up.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 33496

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next