No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VPWS to Access the Public Network or an L3VPN

Configuring a VPWS to Access the Public Network or an L3VPN

This section describes how to configure a VPWS to access the public network or an L3VPN. To achieve this, you can deploy a VPWS on the access network.

Usage Scenario

On the network shown in Figure 10-3, to enable a user to access the public network or an MPLS L3VPN through an MPLS L2VPN, deploy a VPWS on the access network.

Figure 10-3 Configuring a VPWS to access an L3VPN

Pre-configuration Tasks

Before configuring a VPWS to access an L3VPN, complete the following tasks:

  • Connect interfaces and configure their physical parameters for these interfaces to go Up at the physical layer.

  • Enable an IGP on the MPLS access network for IP connectivity.

  • Enable MPLS L2VPN on UPEs and NPEs.

  • Create L2VPN tunnels between UPEs and NPEs.

  • For LDP PWs: create LDP sessions between UPEs and NPEs.

  • For BGP PWs: create BGP sessions between UPEs and NPEs.

  • Create remote LDP sessions if NPEs and UPEs are not directly connected.

  • Enable an IGP on the MPLS bearer network for IP connectivity.

  • Configure basic L3VPN functions on NPEs.

Configuration Procedures

Figure 10-4 Flowchart for configuring a VPWS to access the public network or an MPLS L3VPN

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27451

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next