No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an L3VE Interface

Creating an L3VE Interface

This section describes how to configure an L3VE interface to access an L3VPN and how to bind the L3VE interface to a VE group.

Context

Perform the following steps on an NPE:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface virtual-ethernet interface-number

    A VE interface is created and the VE interface view is displayed.

  3. Run ve-group ve-group-id l3-access

    The VE interface is configured as an L3VE interface to access an L3VPN and is bound to a VE group.

    NOTE:
    • A VE group has only one L2VE interface and one L3VE interface. The two VE interfaces in a VE group must be on the same board. Only the L3VE interface can work in QinQ or dot1q termination mode.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27810

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next