No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a BGP Peer to Be Added to a Labeled Address Family

Configuring a BGP Peer to Be Added to a Labeled Address Family

To establish an inter-AS BGP LSP, enable ASBRs to exchange labeled IPv4 routes with each other.

Procedure

  • Enable ASBRs to exchange labeled IPv4 routes.

    Perform the following steps on each ASBR:

    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of the interface connecting a peer ASBR is displayed.

    3. Run mpls

      MPLS is enabled.

    4. Run commit

      The configuration is committed.

    5. Run quit

      Return to the system view.

    6. Run bgp as-number

      The BGP view is displayed.

    7. Run peer ipv4-address as-number as-number

      , The peer ASBR is configured as an EBGP peer.

    8. Run ipv4-family labeled-unicast

      The BGP unicast labeled address family view is displayed.

    9. Run peer ipv4-address enable

      An IPv4 address is configured for the EBGP peer in the independent labeled address family, and the EBGP peers are enabled to exchange labeled IPv4 routes.

    10. Run quit

      Return to the system view.

    11. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 32870

Downloads: 59

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next