No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static VPWS Accessing VPLS

Configuring Static VPWS Accessing VPLS

This section describes how to configure static VPWS accessing VPLS when UPEs do not support VPLS.

Procedure

  1. Configure SVC VPWS.
  2. Configure static VPLS.
    1. Configure static VPLS.
    2. (Optional) Run mac-withdraw enable and interface-status-change [ up | down ] mac-withdraw enable

      MAC Withdraw is enabled.

      If you do not perform this step, a traffic forwarding error may occur before MAC addresses are aged out.

    3. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 36285

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next