No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Traffic Statistics of a VPLS PW

Checking the Traffic Statistics of a VPLS PW

After configuring the VPLS traffic statistics collection function, check VPLS PW traffic information.

Context

NOTE:

If a PW goes Down within 5 minutes, traffic before the PW goes Down cannot be used to compute the traffic rate in the 5 minutes.

Before checking the public network traffic statistics of an LDP VPLS PW with a specified VSI name, run the traffic-statistics enable or traffic-statistics peer commands.

Before checking the public network traffic statistics about a VPLS PW with the specified VSI name, perform the following operations as needed:
  • Run the traffic-statistics enable or traffic-statistics peer commands in the VSI-LDP view if the target PW is an LDP VPLS PW.
  • Run the traffic-statistics peer enable command in the VSI-BGP view if the target PW is a BGP VPLS PW.

Run the traffic-statistics packet-type enable command in the VSI view check packet-type-based traffic statistics about the VPLS PW with the specified VSI name.

After the traffic statistics collection function is configured for a VPLS PW, you can run the following command in any view to check the running status of the traffic on the VPLS PW.

Procedure

  • Run the display traffic-statistics vsi vsi-name [ peer peer-address [ negotiation-vc-id vc-id | ldp129 | remote-site remote-site-id ] ] command to check the public network traffic statistics of an LDP, FEC 129 or BGP VPLS PW with the specified VSI name.
  • Run the display traffic-statistics vsi vsi-name suppression peer peer-address [ negotiation-vc-id negotiation-vc-id ] command to check the traffic suppression statistics about the VPLS PW with a specified VSI name.
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 37038

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next