No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating the L3VE Sub-interface Terminated by QinQ

Creating the L3VE Sub-interface Terminated by QinQ

If an L3VE sub-interface receives double-tagged service data packets from the UPE, configure the L3VE sub-interface as a sub-interface for QinQ VLAN tag termination to access the L3VPN.

Context

Do as follows on NPEs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface virtual-ethernet interface-number.subinterface-number

    A L3VE sub-interface is created the sub-interface view is displayed.

    You can create sub-interfaces only on the L3VE interface that operates in user termination mode.

  3. Run control-vid vid qinq-termination

    The sub-interface is encapsulated into the QinQ termination mode.

  4. Run qinq termination pe-vid pe-vid [ to high-pe-vid ] ce-vid ce-vid [ to high-ce-vid ] [ vlan-group group-id ]

    The QinQ termination is configured for the L3VE sub-interface.

    When the L3VE sub-interface receives packets with double tags from users, it will terminate the packets whose inner tag is in the range specified by the ce-vid.

  5. Run arp broadcast enable

    The ARP broadcast function is enabled for the sub-interface for QinQ VLAN tag termination.

    When you enable or disable the ARP broadcast function on a termination sub-interface, the routing status of the sub-interface becomes Down and then Up. This may result in a flapping of routes on the entire network, affecting the normal operation of services.

  6. Run ip binding vpn-instance vpn-instance-name

    The L3VE sub-interface is associated with a VPN instance.

  7. Run ip address ip-address { mask | mask-length } [ sub ]

    The IP address is configured.

    NOTE:

    The IP address is a private network address of MPLS L3VPN.

  8. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 28178

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next