No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static VPLS

Configuring Static VPLS

Static VPLS is implemented using manually configured Layer 2 VC information.

Usage Scenario

If devices are unable to support large numbers of LDP sessions or you want to manually manage and allocate VC labels, configure static VPLS. When VPLS PWs are created using manually configured VC labels, Layer 2 VC or link information does not need to be transmitted using LDP.

Pre-configuration Tasks

Before configuring static VPLS, complete the following tasks:

  • Configure IP addresses and IGP routes on PEs and Ps.

  • Configure LSR IDs and enable MPLS and MPLS LDP on PEs and Ps.

  • Enable MPLS L2VPN on PEs.

  • Establish MPLS tunnels between PEs to transmit service data.

Configuration Procedures

Figure 9-2 Configuring static VPLS

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 30161

Downloads: 55

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next