No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VPLS Between SPEs

Configuring VPLS Between SPEs

The VPLS configuration between SPEs is the same as the configuration of ordinary VPLS.

Context

The VPLS configuration between SPEs is the same as the configuration of ordinary VPLS. For details, see Configuring LDP VPLS.

Procedure

  1. Run:

    vsi vsi-name [ static ]

    The VSI view is displayed.

  2. Run:

    isolate spoken [ include-multicast ]

    Forwarding isolation is enabled between AC interfaces, between UPE PWs, and between AC interfaces and UPE PWs in a VSI.

    By default, traffic can be forwarded between AC interfaces, between UPE PWs, and between AC interfaces and UPE PWs in a VSI.

    If the users using the same service are bound in the same VSI, run the isolate spoken command to forbid the users from accessing each other.
    • On a non-hierarchical VPLS network, VSI service isolation prohibits traffic forwarding between AC interfaces.
    • On a Hierarchical Virtual Private LAN Service (HVPLS) network, VSI service isolation prohibits traffic forwarding between AC interfaces, between UPE PWs, and between AC interfaces and UPE PWs.

  3. (Optional) Run:

    quit

    Return to the system view.

  4. (Optional) Run:

    interface interface-type interface-number

    The AC interface view is displayed.

  5. (Optional) Run:

    hub-mode enable

    The VSI attribute on the AC interface is changed from spoke to hub.

    After you run the isolate spoken command, traffic forwarding is prohibited between AC interfaces in a VSI. If a sub-interface in the VSI needs to interwork with other sub-interfaces in the VSI, you must run the hub-mode enable command on the sub-interface to change the VSI attribute from spoke to hub.

  6. Run:

    commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27645

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next