No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling BGP Peers to Exchange Route Information

Enabling BGP Peers to Exchange Route Information

BGP peers need to be enabled to exchange route information in the L2VPN-AD address family view.


BGP AD VPLS shares a TCP connection with BGP. Most BGP AD VPLS configurations are the same as BGP configurations. Unlike BGP, BGP AD VPLS requires the exchange of route information between BGP peers. BGP peers need to be enabled to exchange route information in the L2VPN-AD address family view.


  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer ipv4-address as-number as-number

    A BGP peer is configured.

    ipv4-address is the remote LSR ID.

  4. Run l2vpn-ad-family

    The L2VPN-AD address family view is displayed.

  5. (Optional) Run vpn-orf enable

    The ORF is enabled.

  6. Run peer ipv4-address enable

    A peer is specified, and the function to exchange route information with the specified peer is enabled.

    After you specify a peer in the BGP-L2VPN-AD address family view, the BGP AD signaling capability is enabled by default.


    ipv4-address in this command is the same as ipv4-address specified in the peer command in the BGP view, which is the remote LSR ID.

  7. Run commit

    The configuration is committed.

Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 36583

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next