No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Configuration Guide - VPN
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VPWS PW

Configuring a VPWS PW

Before configuring a static PW, you must specify the VC label.

Context

Perform the following steps on the PEs at both ends of a PW to be established:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls l2vpn

    MPLS L2VPN is enabled.

  3. Run quit

    Return to the system view.

  4. Run interface interface-type interface-number [ .subinterface-number ]

    The AC interface view is displayed.

  5. (Optional) Run mpls l2vpn description description-text

    An L2VPN description is configured for the AC interface.

  6. (Optional) Run mpls l2vpn pw performance disable

    PW performance statistics collection is disabled.

  7. Run either of the following commands:

    • To establish a VPWS PW using Ethernet interfaces, run:

      mpls static-l2vc { { destination ip-address | pw-template pw-template-name vc-id } * | destination ip-address [ vc-id ] } transmit-vpn-label transmit-label-value receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | access-port | [ control-word | no-control-word ] | [ raw | tagged ] ] *
    • To establish a VPWS PW using ATM interfaces, run:

      mpls static-l2vc { { destination ip-address | pw-template pw-template-name vc-id } * | destination ip-address [ vc-id ] } transmit-vpn-label transmit-label-value receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | access-port | [ control-word | no-control-word ] | [ max-atm-cells cells-value ] | [ atm-pack-overtime time ] ] *

    • To establish a VPWS PW using Time Division Multiplex (TDM) interfaces, run:

      mpls static-l2vc { { destination ip-address | pw-template pw-template-name vc-id } * | destination ip-address [ vc-id ] } transmit-vpn-label transmit-label-value  receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | access-port | [ control-word | no-control-word ] | [ jitter-buffer depth ] | [ tdm-encapsulation number ] | [ tdm-sequence-number ] | [ idle-code idle-code-value ] | [ rtp-header ] ] *

  8. (Optional) Run mpls l2vpn service-name service-name

    The L2VPN service name is specified. Then, you can use an NMS to maintain the L2VPN service based on the service name.

  9. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058925

Views: 27511

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next