No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Feature Description - IP Services 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Feature Description - IP Services
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DHCP PnP Application

DHCP PnP Application

Service Overview

Device installation is costly and needs to be complete in just one site visit. Engineers are classified into hardware and software commissioning engineers. Hardware engineers install devices and lay out cables. Software commissioning engineers are responsible for initial configuration. Hardware engineers must be on site during device installation. To free software commissioning engineers from configuring devices on site, you can configure DHCP PnP.

After DHCP PnP is configured, the NMS can use DHCP to configure and commission devices on a network remotely. This solution effectively reduces operation and maintenance (O&M) costs.

Networking Description

Figure 4-13 shows a typical mobile bearer network. The NMS is connected to a device at the aggregation layer. A large number of case-shaped UPEs exist on the network and are distributed sparsely. To reduce installation expenditure and improve working efficiency, enable DHCP PnP on the case-shaped UPEs.

Figure 4-13 Mobile bearer network

Feature Deployment

As shown in Figure 4-13, UPEs obtain management IP addresses using DHCP and are configured with NMS parameters automatically. Then the NMS management channel is available to allow the NMS to make a Telnet connection to UPEs and configure them remotely.

Updated: 2019-01-14

Document ID: EDOC1100058931

Views: 9855

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next