No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Feature Description - LAN Access and MAN Access 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Feature Description - LAN Access and MAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Is Load Balancing

What Is Load Balancing

Load balancing means that network nodes distribute traffic among multiple links during transmission. Route load balancing, tunnel load balancing, and trunk load balancing are available.

Route Load Balancing

Route load balancing means that traffic is load-balanced over multiple forwarding paths to a destination, as shown in Figure 8-1.

Figure 8-1 Route load balancing networking

If the Forwarding Information Base (FIB) of a device has multiple entries with the same destination address and mask but different next hops, outbound interfaces, or tunnel IDs, route load balancing can be implemented.

NOTE:

Route load balancing can be implemented in either of the following solutions:

  • Solution 1: Configure multiple equal-cost routes with the same destination network segment but different next hops and the maximum number of equal-cost routes for load balancing. This solution is mostly used among links that directly connect two devices. However, this solution is being replaced with the trunk technology as the trunk technology develops. Compared with this solution, the trunk technology saves IP addresses and facilitates management by bundling links into a trunk.
  • Solution 2: Separate destination IP addresses into several groups and allocate one link for each group. This solution improves the utilization of bandwidth resources. However, if you use this solution to implement load balancing, you must observe and analyze traffic and know the distribution and trends of traffic of various types.

Tunnel Load Balancing

Tunnel load balancing is applicable when the ingress PE on a VPN has multiple tunnels to a destination PE, as shown in Figure 8-2. Traffic can be load-balanced among these tunnels.

Figure 8-2 Tunnel load balancing networking

Trunk Load Balancing

Trunk load balancing means that traffic is load-balanced among trunk member links after multiple physical interfaces of the same link layer protocol are bundled into a logical data link, as shown in Figure 8-2.

Figure 8-3 Trunk load balancing networking

Load Balancing Characteristics

Advantages:

  • Load balancing distributes traffic among multiple links, providing higher bandwidth than each individual link and preventing traffic congestion caused by link overload.
  • Links used for load balancing back up each other. If a link fails, traffic can be automatically switched to other available links, which increases link reliability.

Disadvantages:

Traffic is load-balanced randomly, which may result in poor traffic management.

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058932

Views: 6019

Downloads: 9

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next