No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Feature Description - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Feature Description - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
HSI Service Bearer Using PWE3

HSI Service Bearer Using PWE3

Service Overview

High speed Internet (HSI) services are provided over IP networks. As shown in Figure 6-35, users access the broadband remote access server (BRAS) by means of Ethernet access. Usually:
  • DSLAMs are far away from a BRAS, and an intermediate network is required to connect them.
  • Large numbers of DSLAMs are deployed on a network, but the number of DSLAMs for which each BRAS can provide access services is limited and a BRAS is expensive.
To resolve the preceding issues, establish a PWE3 network between the DSLAMs and BRAS. Multiple DSLAMs are connected to the BRAS in Layer 2 aggregation mode, improving BRAS usage efficiency and reducing costs.

HSI services are data services that do not require low delays. Access and bearer networks can meet the following requirements:

  • Strong expansibility
  • Clear management responsibilities
  • Effective control on Layer 2 broadcast domains
  • Guaranteed user data security
  • Support for multiple protocols and smooth network upgrade
  • Convenient configuration

Networking Description

In Figure 6-35, digital subscriber line access multiplexers (DSLAMs) converge HSI service packets to UPEs through VLANs. The UPEs transmit the packets to the NPE through PWs. After receiving the packets, the NPE removes PW labels, adds VLAN tags to the packets, and transmits the packets to the BRAS. The BRAS removes the VLAN tags. HSI service users dynamically access the BRAS by means of Ethernet access to obtain IP addresses.
Figure 6-35 Networking for HSI service bearer using PWE3

Feature Deployment

  1. IP addresses and IGPs are configured on the carrier's MPLS backbone network for communication between PEs.
  2. MPLS is enabled on the carrier's backbone network. TE tunnels are configured between UPEs and NPEs. Usually, two TE tunnels are configured between each UPE and NPE, one as the primary tunnel and the other as the backup tunnel.
  3. MPLS L2VPN is enabled on each UPE and NPE. A remote MPLS LDP session is configured between each UPE and NPE.
  4. PWE3 is configured on AC interfaces of each UPE and NPE, so that UPEs and NPEs can communicate over MPLS L2VCs.
Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058940

Views: 13245

Downloads: 30

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next