No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Feature Description - VPN 01

NE05E and NE08E V300R003C10SPC500

This is NE05E and NE08E V300R003C10SPC500 Feature Description - VPN
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using EVPN to Interconnect Other Networks

Using EVPN to Interconnect Other Networks

On the network shown in Figure 10-38, to interconnect different sites through a public network, deploy EVPN by performing the following configurations:
  • Configure a PE on the backbone network as an EVPN RR and the other PEs as RR clients. Establish BGP EVPN peer relationships between the RR and clients, but not between the clients. To improve reliability, you can configure two EVPN RRs, one as the master and the other as the backup.

  • Create EVPN instances on PEs. Configure the same RT values for the PEs to allow EVPN route cross.

  • Configure PE redundancy. If all PEs connecting to the same CE are configured to work in All-Active mode, these PEs load-balance traffic destined for the CE.

Figure 10-38 EVPN application networking

Translation
Download
Updated: 2019-01-14

Document ID: EDOC1100058940

Views: 19662

Downloads: 36

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next