No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CloudEC V600R019C00 Fault Information Collection (Enterprise On-premises, Convergent Conference)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting Network Information

Collecting Network Information

You can use the OMU to manually collect networking information. You can determine the current networking mode based on the collected networking information.

General Principle

Networking information is the basic information for locating and analyzing problems. Collecting networking information facilitates fault locating.


  1. Log in to the HUAWEI Operation & Maintenance System.
  2. In the MML Command - USM window, run LST DEPLOYMODE to query the networking information.
  3. Save the information displayed in the query result.

    RETCODE = 0  Operation succeeded
    The result is as follows:
    Deploy mode  =  SENCE2(Settled-CloudEC)
    (Number of results = 1)
    ---    END

    The preceding Deploy mode = SENCE2(Settled-CloudEC) is an example. The networking mode displayed in the command output is based on the actual networking information, for example, IMSHosted .

Updated: 2019-08-07

Document ID: EDOC1100059082

Views: 7180

Downloads: 2

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next