No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CloudEC V600R019C00 Fault Information Collection (Enterprise On-premises, Convergent Conference)

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Network Test

Network Test

Table 22-3 Network test


Item to Be Tested

Signal Stream


IP access

endpointRP → LAN or public network

Before a test, verify that the LAN network port indicator is green, which indicates that your endpointRP is correctly connected to an IP network.

  • In Address, enter an IP address or domain name that is in a different network segment from your endpointRPIP address. Then click Start. If the test succeeds, the gateway settings and IP address of your endpointRP are correct.
  • If your endpointRP is on a private network, in Address, enter a public IP address or domain name. Then click Start. If the test succeeds, the gateway settings, NAT address, and IP address of your endpointRP are correct.
Updated: 2019-04-01

Document ID: EDOC1100059082

Views: 6351

Downloads: 2

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next