No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CloudEC V600R019C00 Security Maintenance (Enterprise On-premises, Only Conference)

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling IP Call

Disabling IP Call

The IP call function is disabled on the VP9600 series MCUs by default. For the communication security purposes, disable the IP call function if it is enabled.

  1. Use the PuTTY tool to log in to a VP9600 series MCU.
  2. After the <HUAWEI VP9650> prompt, enter sys conf-policy and press Enter.
  3. After the [HUAWEI VP9650–Conf-Policy] prompt, enter enable-ip-call and press Enter.
  4. Enter 0 and press Enter to disable the IP call function.
  5. Enter q and press Enter to return to the root directory.
  6. After the <HUAWEI VP9650> prompt, enter save and press Enter.

    The following information is displayed:

    are you sure to save config?(y/n)

  7. Enter y to confirm the saving.
  8. Run the display conf-policy command to check whether enable IP Call is set to disable. If yes, the IP call function is disabled.
Translation
Download
Updated: 2019-08-07

Document ID: EDOC1100059091

Views: 18132

Downloads: 10

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next