No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI NIP6800 Series V500 Hardware Guide

This document of the NIP6800 Series describes hardware structure, installation guide, and hardware maintenance. The content of this document includes the appearance and specifications of the product, the supported expansion cards, preparation before the installation, installation, cabling, and hardware replacement.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing Boards and Subcards

Installing Boards and Subcards

This section describes how to install boards and subcards.

Context

  • Ensure that the device and board are completely dry and free of liquid before inserting the board into the device.

  • Before installing boards, wear the ESD wrist strap and ensure that the strap is well grounded to prevent any electrostatic discharge from damaging sensitive components.

Procedure

  1. Select slots based on slot distribution.

    You can determine whether a slot is suitable for a board by checking whether the color on both ends of the board panel is the same as the color on the slot.

    Figure 2-31  Slot layout

  2. Install a board.
    1. Remove the filler panel from the selected slot.
    2. Extend the ejector levels of the board, insert the board fully into the slot, and rotate the ejector level to the front of the board.
    3. Use a Phillips screwdriver to fasten the captive screws to the board.

    Figure 2-32  Installing a board

  3. Install a subcard.

    NOTE:

    Before you install a subcard, remove redundant guide rails from the board and store them for future use.

    1. Remove the filler panel from the board.
    2. Smoothly insert the subcard into the board along the guide rail.
    3. Use a Phillips screwdriver to fasten the captive screws to the board.

    Figure 2-33  Installing a subcard

Follow-up Procedure

Verify the following:

  • Boards and subcards are installed in the correct position and captive screws are tightly fastened.
  • Filler panels are inserted into vacant slots. Filler panels prevent intrusion of dust and ensure heat dissipation.
Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059253

Views: 13959

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next