No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI NIP6800 Series V500 Hardware Guide

This document of the NIP6800 Series describes hardware structure, installation guide, and hardware maintenance. The content of this document includes the appearance and specifications of the product, the supported expansion cards, preparation before the installation, installation, cabling, and hardware replacement.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Power Cable

Replacing a Power Cable

This section describes the procedure for replacing a power cable.

Context

Before replacing a power cable, note the following:

  • Ensure that service data is backed up before replacing a power cable.

  • Before operating the device, make sure to cut off all input power supplies to the power distribution cabinet, and label the switch to be used.

  • The DC power cable terminals and other exposed surfaces must be fully insulated.

Tool

Before replacing a power cable, you need the following tools:

  • Power module terminal

  • Power cable

  • ESD wrist strap

  • Phillips screwdriver

Procedure

  1. Record the location of both ends of the power cable to be replaced and the cabling mode.
  2. Make a new power cable. For details, refer to On-site Cable Assembly and Installation.
  3. Loosen the screws on the terminal of the power module with a wrench. Then, remove the terminal. Pull out the power cable from the guide-in hole on the cabinet.
  4. Install the power cable. Pass the new power cable through the guide-in hole on the cabinet, and connect the terminal of the power module to the input terminal of the power module in the power distribution cabinet. Then, tighten the setscrews with a wrench.
  5. Make new labels according to the contents of the labels on the old power cable. For label regulations, refer to the Engineering Labels for Cables.

Follow-up Procedure

  • Gather up and store the tools and the old cable.
  • Separate the old and new cables to avoid confusion.
Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059253

Views: 14646

Downloads: 26

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next