No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI NIP6800 Series V500 Hardware Guide

This document of the NIP6800 Series describes hardware structure, installation guide, and hardware maintenance. The content of this document includes the appearance and specifications of the product, the supported expansion cards, preparation before the installation, installation, cabling, and hardware replacement.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Network Cable

Replacing a Network Cable

This section describes the procedure for replacing a network cable.

Context

Before replacing a network cable note the following:

  • When network cables are replaced, services are interrupted temporarily.

  • Replace network cables during a time when the network is not busy, for example, between 00:00 am and 06:00 am.

Tool

Before replacing a network cable, you need the following tools:

  • Cutter

  • Cable ties

  • ESD wrist strap or ESD gloves

  • Cable tester

  • Crimper

Procedure

  1. Check the location and cabling of the network cable to be replaced.
  2. Prepare a new network cable that of the same type as old network cable. After a new network cable is made, test its connectivity with a cable tester.
  3. Put on the ESD gloves or wrist strap and connect the grounding terminal to the ESD jack on the rack.
  4. Lay out the new network cable according to the original cabling mode.

    If you need to replace more than one network cable at a time and label the new network cables so that you can distinguish between them. The new network cables must be numbered consistently with the network cables to be replaced.

  5. Remove the old network cable and record the location where it is installed.
    1. Remove the network cable connectors.
    2. Cut the cable tie with a cutter and remove the network cable.
  6. Insert the new network cable connector into the network interface at the reported location. If you hear a click, the connector is fully inserted. If the indicator of the network interface is steady green, the link is Up.
  7. Label the new network cable, as shown in Figure 3-42.

    Figure 3-42  Labeling a new network cable

  8. Bind the cable with a cable tie and cut off any extra lengths of tie.
  9. Run the ping command to check the connection between both ends of the new network cable. If both ends fail to communicate normally, check whether the network cable is damaged or connectors are secure.

Follow-up Procedure

  • Gather up and store the tools and the old cable.
  • Separate the old and new cables to avoid confusion.
Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059253

Views: 15945

Downloads: 26

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next