No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI NIP6800 Series V500 Hardware Guide

This document of the NIP6800 Series describes hardware structure, installation guide, and hardware maintenance. The content of this document includes the appearance and specifications of the product, the supported expansion cards, preparation before the installation, installation, cabling, and hardware replacement.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Network Cables

Connecting Network Cables

This section describes how to install electrical transceivers on the ports and how to connect them to the peer device ports using network cables according to the network plan.

Context

Before connecting the network cable, check the following:
  • Construction conditions

    Ensure that the peer device has been installed in the equipment room and the port to which the network cable is to be connected has been determined.

  • Cabling route

    The engineering document specifies the cabling route from the cabinet to the peer device in the equipment room. Ensure that the cable length is calculated based on the cabling path.

  • Cable label

    Ensure that the cable is labeled before being connected to the devices.

Network cables are either crossover or straight-through cables. Currently, Ethernet ports on most devices can dynamically adapt to both types of cables. For devices that do not support dynamic adaptation, use the correct cables.

In terms of electromagnetic compatibility, network cables are either ordinary or shielded cables. Shielded cables are preferred because of their higher electromagnetic compatibility.

Before connecting a cable, ensure that the port is labeled and that the cable is inserted into the correct port. Otherwise, the port module or the device may be damaged.

Before bundling network cables, use a network cable tester to test cable connectivity. Bind the network cables to form a rectangle inside the cabinet. Each bundle contains a maximum of 20 network cables. Ensure that the cable ties are tidy and tied in the same direction.

The distance between the power cable, PGND cable, and signal cable must be greater than 30 mm.

Procedure

  1. If multiple network cables need to be connected, attach temporary labels to both ends of each cable.
  2. Remove the dust-proof caps from a board interface and insert the electrical module into the interface.

    NOTE:

    The electrical module can be inserted only in odd-numbered interfaces on the 24-port 100/1000Base-X-SFP flexible interface card.

  3. Connect one end of a network cable to the electrical transceiver of the NIP6860 and the other end to the Ethernet port of the peer device based on the network plan.

    Figure 2-38  Connecting a network cable

  4. Lay out the network cable along a cabinet and route the cable through the cable hole for the signal cables at the top (overhead cabling) or bottom (underfloor cabling) of the cabinet.
  5. Remove the temporary labels. Attach labels (20 mm away from the connectors) at each end of the network cable.

Follow-up Procedure

Verify the following:

  • The labels at each end of the cable are correct, clear, neat, and facing the same direction.

  • The cables and connectors are free of any damage and are connected properly and securely.

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059253

Views: 13854

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next