Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing NIP6830
This section describes how to install the NIP6830.
- Preparing the Site
Prior to device installation, deploy the cabinet and device according to the following power supply, cabinet, cabinet clearance, and device clearance requirements to ensure that the device works properly. - Installing Cable Racks and Mounting Ears
Mounting ears are used to fix a device to the cabinet, and cable racks are used to route optical fibers and cables. - Installing the Chassis into the Cabinet
You can install the NIP6830 in a 19-inch standard cabinet using guide rails. - Connecting the PGND Cable
Correctly connecting the PGND cable of the NIP6830 is essential for surge protection and interference resistance. Before using the NIP6830, connect the PGND cable. - Installing Boards and Subcards
This section describes how to install boards and subcards. - Installing Power Cables - DC Power Distribution
In standard configuration, the NIP6830 has two DC power supply modules. Each module requires an NEG DC power cable and an RTN DC power cable. This section describes how to connect power cables to the two DC supply modules. - Installing Power Cables - AC Power Distribution
In standard configuration, the NIP6830 has two AC power supply modules. Each module requires a power cable. This section describes how to connect power cables to the two AC supply modules. - Connecting Network Cables
This section describes how to install electrical transceivers on the ports and how to connect them to the peer device ports using network cables according to the network plan. - Connecting Optical Fibers
This section describes how to install optical transceivers on the ports and connect them to the ports of the peer device using optical fibers according to the network plan. - Post - Installation Checklists
After you install the device in a cabinet and before you power on the device, verify that the cables and NE40E have been installed correctly. - Powering On the NIP6830 - DC
Power Distribution
Check whether the NIP6830 is operating properly with the DC power supply. Power on the NIP6830 according to the following requirements to ensure device security. - Powering On the NIP6830 - AC
Power Distribution
Check whether the NIP6830 is operating properly with the AC power supply. Power on the NIP6830 according to the following requirements to ensure device security.
Previous
