No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Configuration Guide - IP Routing 01

This is ME60 V800R010C10SPC500 Configuration Guide - IP Routing
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for OSPF

Licensing Requirements and Limitations for OSPF

Licensing Requirements

This feature is a basic feature and is not under license control.

Restrictions and Guidelines

Restrictions

Guidelines

Impact

OSPF checks whether a neighbor in the full state exists in the backbone area before advertising a default route to the stub area.

Plan configurations properly.

Default routes fail to be delivered.

OSPF advertises default routes to an NSSA only when at least neighbor in the full state exists in the backbone area or default routes of another protocol or of another OSPF process exists in the same VPN instance, and the nssa default-route-advertise command is run.

Plan configurations properly.

Default routes fail to be delivered.

When a device in an NSSA generates an NSSA LSA based on an imported external route, the device preferentially uses the IP address of a loopback interface in the NSSA as the forwarding address (FA). If no loopback interfaces exist in the NSSA, the device selects the IP address of a non-loopback interface. As a result, the downstream device may fail to implement load balancing using routes even when links with the same cost exist.

Plan configurations properly and determine whether to enable OSPF on the loopback interface.

Load balancing fails to be implemented, which may cause link congestion.

Before running the undo ospf process-id command to delete an OSPF process, you need to check whether segment routing is enabled. If segment routing is enabled, you need to disable it before deleting the OSPF process. Otherwise, Opaque LSAs may remain unexpectedly due to the Opaque capability change if the process is reconfigured.

Before running the undo ospf process-id command to delete an OSPF process, you need to check whether segment routing is enabled. If segment routing is enabled, you need to disable it before deleting the OSPF process. Otherwise, Opaque LSAs may remain unexpectedly due to the Opaque capability change if the process is reconfigured.

The residual Opaque LSAs are used for calculation. As a result, a calculation error occurs and may last for a maximum of 3600s.

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059437

Views: 20343

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next