No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


ME60 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access 01

This is ME60 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling GVRP

Enabling GVRP


You must enable GVRP globally as well as on trunk interfaces which require dynamic VLAN registration and deregistration. In addition, you must enable packets of all dynamic VLANs to pass the trunk interfaces.


  1. Run system-view

    The system view is displayed.

  2. Run gvrp

    GVRP is enabled globally.

  3. Run interface interface-type interface-number

    The interface view is displayed.

  4. Run port link-type trunk

    The interface is configured as a trunk interface.

  5. Run port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }

    VLANs in which packets are allowed to pass the trunk interface are specified.

  6. Run gvrp

    GVRP is enabled on the trunk interface.

    By default, GVRP is disabled globally and on each interface.


    VLAN configuration will trigger GVRP messages. If a large number of VLANs require configuration, configure VLANs in batches on devices one by one and configure timers to control the sending of GVRP messages. Otherwise, dynamic VLANs may flap.

    If a trunk interface is switched to an access, hybrid, or dot1q-tunnel interface, you are prompted to enable interface GVRP.

    The blocked interface in instance 0 of Spanning Tree Protocol (STP)/Rapid STP (RSTP)/Multiple STP (MSTP) blocks GVRP PDUs. To ensure that GVRP runs properly and to prevent GVRP loops, do not enable GVRP on blocked interfaces of ring network protocols, such as STP, RSTP, and MSTP.

  7. Run commit

    The configuration is committed.

Updated: 2019-01-04

Document ID: EDOC1100059440

Views: 27109

Downloads: 18

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next