No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access 01

This is ME60 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Port Priority in an MSTI

(Optional) Configuring a Port Priority in an MSTI

The lower the numerical value, the more likely the port on a switching device becomes a designated port; the higher the numerical value, the more likely the port is to be blocked.

Context

In spanning tree calculation, priorities of ports on switching devices in Multiple Spanning Tree Instances (MSTIs) determine designated port selection.

If you expect to block a port on a switching device in a Multiple Spanning Tree Instance (MSTI) to eliminate loops, set the port priority value to be larger than the default value. This port will be blocked in designated port selection.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the Ethernet interface participating in STP calculation is displayed.

    NOTE:
    The following configuration can be configured both on a Layer 2 interface and a Layer 3 interface.

  3. Run stp instance instance-id port priority priority

    A port priority is set in an MSTI.

    The value range of the priority is from 0 to 240, with the step 16. That is, the port priority can be 0, 16, or 32.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059440

Views: 26762

Downloads: 18

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next